JVC HR-XVS20EK - Manual (Page 83)

Masterpage:Right-No-Heading
83
Filename [XVS20EK_10Subsidiary.fm]
Page 83 March 28, 2003 6:57 pm
Set Stations (B)
Set station names other than the ones registered in your unit.
A
Select the character for station name.
B
Enter the new character.
Press rt to cycle through the characters (A–Z, 0–9, –,
f
, +,
I
(space) ) and stop when the desired character is
indicated, then press e to enter. Enter the remaining
characters the same way (maximum of 4). After entering
all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press w until the incorrect character
begins blinking. Then enter the correct character by pressing
rt.
C
Close the Confirmation screen.
Press SET UP MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–,
f , +, I (space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
Press rt w e until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press e until “+/–” begins blinking, then press rt until
the picture is its clearest. Then press OK.
● The Confirmation screen appears.
● Repeat steps A – C as necessary.
D
Close the Confirmation screen.
Press SET UP MENU.
Perform steps A and B of “Manual Channel Set” on page 80
to access the Confirmation screen and then perform steps A
and B of “Set Stations (A)” above before continuing.
Press e until the first letter of
the station name begins
blinking.
Perform steps A and B of “Manual Channel Set” on page 80
to access the Confirmation screen before continuing.
XVS20EK_01.book Page 83 Friday, March 28, 2003 7:00 PM