Speaker setup – Integra DTR-9.1 User Manual
Page 80
Upgraded-
4
Speaker Setup
Menu
1.Speaker Setup
2.Input Setup
3.Listening Mode Setup
4.Preference
5.Zone2 OSD Setup
6.About
Select: Exit:|EXIT|
Enter:|ENTER| Quit:|OSD|
1.Speaker Setup
1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Bass Peak Level
5.LFE Level
Quit:|OSD|
1-1.Speaker Config
a.Subwoofer :Yes
b.Front L/R :Large
c.Center :Large
d.Surround L/R
:Large
e.Surround Back
:Large
f.Crossover:80Hz(THX)
Quit:|OSD|
1-1. Speaker Config sub-menu
Here you will enter which speakers are connected and
the size of each speaker.
a. Subwoofer
Yes: Select when a subwoofer is connected.
No: Select when a subwoofer is not connected.
b. Front L/R
Large: Select if the front speakers are large sized.
Small: Select if the front speakers are small sized.
• If “No” is selected for the Subwoofer setting, then this
setting is fixed to “Large.”
c. Center
None: Select if no center speaker is connected.
Large: Select if the center speaker is large sized.
Small: Select if the center speaker is small sized.
• If “Small” is selected for the Front setting, then “Large”
cannot be selected for this setting.
d. Surround L/R
None: Select if no surround left and right speakers are
connected.
Large: Select if the surround left and right speakers are
large sized.
Small: Select if the surround left and right speakers are
small sized.
• If “Small” is selected for the Front setting, then “Large”
cannot be selected for this setting.
e. Surround Back
None: Select if no surround back left and right
speakers are connected.
Large: Select if the surround back left and right
speakers are large sized.
Small: Select if the surround back left and right
speakers are small sized.
• If “None” is selected for the Surround L/R setting, then
this setting is fixed to “None.”
• If “Small” is selected for the Surround L/R setting, then
“Large” cannot be selected for this setting.
f. Crossover
This setting allows you to set the crossover frequency for
your speaker system. The crossover frequency is the
minimum frequency delivered to a speaker and can be
set to 40 Hz, 60 Hz, 80 Hz (THX), 100 Hz, or 120 Hz. This setting
is valid when “Subwoofer” is set to “Yes,” or for speakers
that are set to “Small,” at the “Speaker Config” menu.
Frequencies below this are cut from speakers set to
“Small” and sent to the subwoofer (or to speakers set to
“Large”).