IBM SSA 32H3816 User Manual

Page 56

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ 50007 ¦ The IOCC detected an internal ¦ Exchange the adapter card ¦

¦ ¦ error. ¦ for a new one or call for ¦

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ 50008 ¦ Unable to read or write the ¦ Exchange the adapter card ¦

¦ ¦ PCI registers. ¦ for a new one or call for ¦

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ 50010 ¦ An SSA adapter or device ¦ Call for service ¦

¦ ¦ drive protocol error has ¦ ¦

¦ ¦ occurred. ¦ ¦

+---------+-------------------------------+------------------------------¦

¦ 50012 ¦ The SSA adapter microcode has ¦ Call for service ¦

¦ ¦ hung. ¦ ¦

+---------+-------------------------------+------------------------------¦

¦ D4000 ¦ The diagnostics cannot ¦ Exchange the adapter card ¦

¦ ¦ configure the SSA adapter. ¦ for a new one or call for ¦

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ D4100 ¦ The diagnostics cannot open ¦ Exchange the adapter card ¦

¦ ¦ the SSA adapter. ¦ for a new one or call for ¦

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ D4300 ¦ The diagnostics have detected ¦ Exchange the adapter card ¦

¦ ¦ an SSA adapter POST failure. ¦ for a new one or call for ¦

¦ ¦ ¦ service ¦

+---------+-------------------------------+------------------------------¦

¦ DFFFF ¦ A command or parameter that ¦ Call for service ¦

¦ ¦ has been sent or received is ¦ ¦

¦ ¦ not valid. This problem is ¦ ¦

¦ ¦ caused either by the SSA ¦ ¦

¦ ¦ adapter, or by an error in ¦ ¦

¦ ¦ the microcode. ¦ ¦

+------------------------------------------------------------------------+

Subtopics

B.1 SSA Loop Configurations that Are Not Valid

SSA RAID Adapter Installation and User's Guide.

Appendix B. SSA RAID Adapter Service Request Numbers

B.0 - 4