IBM X.25 - Manual (Page 35)

A screen similar to the following may appear.
_______________________________________________________________
IBM REALTIME INTERFACE CO-PROCESSOR
AND X.25 INTERFACE CO-PROCESSOR
CARD ADDR = 2A
WERE YOU DIRECTED HERE FROM THE PROBLEM ISOLATION CHARTS
BECAUSE THE YELLOW LIGHT WAS BLINKING
(Y/N)?
_______________________________________________________________
DOES YOUR SCREEN LOOK SIMILAR TO THIS ONE?
NO Continue to the next page.
YES Replace the co-processor adapter.
Configuration Screen
Configuration information for all installed co-processor adapters
should appear on the screen. If a screen with an error message
appears, follow the instructions on the screen.
Notes:
1. The Realtime Interface Co-Processor Advanced Diagnostics are
configured to test up to a maximum of four co-processor
adapters (including the PCI co-processor adapter) at a time. If
you have more than four adapters, ensure that only four at a
time are installed.
2. The following screen is only a representation of the configuration
screen that should be displayed. Your screen may differ,
depending on your co-processor adapter configuration.
Problem Determination Procedures 4-7