2 installing the side rails, Warning, 3 installing the power unit – Invacare MA90Z User Manual
Page 16: Place the control unit on the footboard, Bed hook, Figure 2 installing the power unit, 4 connecting the hose, Caution
4 OPERATION
16
4.2
Installing the Side Rails
4.3 Installing the Power Unit
1.
Pull out the bed hook on the back of the control unit.
2.
Place the control unit on the footboard.
FIGURE 2 Installing the Power Unit
4.4
Connecting the Hose
ƽ
WARNING
Patient entrapment with bed side rails may cause injury or death. Mattress MUST fit bed frame and side rails snugly to
prevent patient entrapment. Follow the manufacturer’s instructions. Monitor patient frequently. Read and understand the
Owner’s/Operator’s Manual prior to using this equipment. Invacare product manuals are available at www.invacare.com or
your dealer.
Refer to the instructions provided with the side rails for the installation procedure.
If the bed does not have a footboard, place the
control unit on a flat surface, leaving room for the
hose to hang down.
Bed Hook
ƽ
CAUTION
Ensure that the hose connecting the control unit to the mattress is routed such that it cannot be stepped on, kinked,
squeezed or otherwise damaged.