10 anti-tippers/wheel locks – Invacare TRACER EX2 User Manual
Page 52
10 ANTI-TIPPERS/WHEEL LOCKS
52
Installing Anti-Tippers
FIGURE 1 Installing Anti-Tippers - Anti-Tipper Length
1.
Press the release buttons and insert the anti-tippers with the anti-
tipper wheels pointing toward the ground/floor into the wheelchair
frame tubing.
2.
Ensure that the release button of the anti-tipper fully protrudes out
of the hole in the bottom of the wheelchair frame tubing.
3.
Place the wheelchair on a flat surface.
4.
Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
FIGURE 2 Installing Anti-Tippers
To ensure the correct model anti-tipper is used refer to chart below. Measurements for anti-tippers are approximate and are taken with
extension tube in bottom hole position.
WHEELCHAIR MODEL
SEAT-TO-FLOOR
HEIGHT IN INCHES
ANTI-TIPPER (MEASUREMENTS IN INCHES)
LENGTH
HEIGHT
MODEL
PART NO.
TRACER EX2
17½ to 19½
13½
3¼
1360
1058836
TRACER EX2 FF
21
12
2¾
9758
1086190
Anti-Tipper Height
Anti-Tipper Length
Flat Surface
Bottom Position
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
Rear Frame Tubing
Anti-Rattle