Front riggings, Installing/removing front riggings, 5 front riggings – Invacare TRACER EX2 User Manual
Page 31
5 FRONT RIGGINGS
31
5 Front Riggings
5.1
Installing/Removing Front Riggings
Installing
1.
Turn the front rigging assembly to the side.
2.
Install the hinge plates on the front rigging assembly onto the hinge pins on the wheelchair frame.
3.
Push the front rigging assembly towards the inside of the wheelchair until it locks into place.
4.
Repeat this procedure for the other front rigging assembly.
5.
To release the front rigging, push the front rigging release lever inward, rotate front rigging outward.
Removing
1.
Push the front rigging release lever inward.
2.
Rotate swingaway front rigging assembly outward.
3.
Lift the swingaway front rigging assembly off the hinge pins.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
When performing STEP 3, it may be necessary to pull release lever toward front of chair to assist the front rigging to lock
in place.
The footplate will be on the inside of the wheelchair when locked in place.