IBM SpotLine M110 - Manual (Page 22)

22
4.1.4 Network Parameters
Use this screen to set your network configuration parameters, including Internet
Address. Usually you only need to set the SpotLine’s IP address and enable the
print server if you are going to use the printer attached to this terminal as a
system wide independent printer.
Spot: The Internet IP address of this terminal, e.g. 194.2.32.52.
Note: This addres must be unique on your network and must be
homogeneous (same class of addresses) to the other terminals on the
network.
Gateway: This IP address is for any gateway on your network. By default if it
Is set to 0.0.0.0. no gateway is being used.
USA-0212-000003
Network Configuration
Internet Address
Spot : 194.2.32.52
Gateway : 0.0.0.0
Name Server : 0.0.0.0
File Server : 0.0.0.0
SubNet Mask : 0.0.0.0
Print Server
Active : [ No ]
Protocol : [ LPD ]
Default Queue Name : DEFAULT
Printer : [ Parallel ]
Print Screen
Mode : [ Local ]
Destination Host : [ None ]
Queue Name :
Enter: Save Arrows/Tab: Next Field F4: Clear Field Esc: Cancel