beautypg.com

Assembly instruction – Impex MXM-5 User Manual

Page 9

background image


ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.

STEP 1 (See Diagram 1)

A.) NOTE: Do not tighten the Nuts and Bolts until instructed to do so.
B.) Connect the Left & Right Base Frames (#17 & #18) by a Cross Brace (#20) in the mid-

span. Secure each end of the Cross Brace with two M10 x 2 ½” Carriage Bolts (#92), one
4 3/8” x 1 ¾” Bracket (#46), two Ø ¾” Washers (#82), and two M10 Aircraft Nuts (#99).

C.) Attach a Front Vertical Beam (#16) to the Left Base Frame (#17). Secure it with two M10 x

2 ¾” Carriage Bolts (#93), one 4 ¾” x 2” Bracket (#47), two Ø ¾” Washers (#82), and two
M10 Aircraft Nuts (#99). Repeat the same procedure to install the other side.

D.) Attach the Front Top Beam (#32) to the two Front Vertical Beams. Secure each end with

one M10 x 2 ½” Allen Bolt (#89), 4” x 2” Bracket (#45), and Ø ¾” Washer (#82) into the top
hole. Secure the bottom hole with one M10 x 2 ¾” Carriage Bolt (#93), Ø ¾” Washer
(#82), and M10 Aircraft Nut (#99).

E.) Insert a Guide Rod (#19) into the hole on the Left Base Frame (#17). Secure it with one

M10 x 1” Allen Bolt (#85) and

¾” Washer (#82) at the bottom.

F.) Slide a Lower Safety Stop Frame (#42) and a Safety Stop Frame (#37) onto the Guide

Rod (#19).

G.) Secure the top of the Guide Rod with one M10 x 1” Allen Bolt (#85) and

¾” Washer

(#82).

H.) Attach a Safety Hook (#43) to the Lower Safety Stop Frame (#42). Secure it with one M10

x 1” Allen Bolt (#85), two

¾” Washers (#82), and one M10 Aircraft Nut (#99).

I.) Attach the Safety Hook to the selected hole on the Front Vertical Beam.
J.) Repeat procedures E through I above to install the other side.














8