Impex MXM-5 - Manual (Page 14)

STEP 4 (See Diagram 4)
A.) Note: Help of another person is strongly recommended for this step. Place the Weight Lifting
Sleeve (#38) in between the two Safety Stop Frames (#37). Align the holes and insert the
Weight Bar (#39) into the Safety Stop Frame from one end through the Weight Lifting Sleeve
to the other Safety Stop Frame on the opposite end. Secure the Weight Bar to each Safety
Stop Frame with a M8 x 3/8” Allen Bolt (#103).
B.) Turn the safety hook on the Weight Lifting Sleeve to secure its position on the selected holes
on the Front Vertical Beams. Slide two Long Olympic Sleeves (#60) onto the Weight Bar.
Attached two Spring Clips (#76) to the Olympic Sleeves.
C.) Attach four Weight Posts (#27) to the Left & Right Base Frames (#17 & #18). Secure each
Post with one M10 x 1” Allen Bolt (#85) and
∅
¾” Washer (#82).
D.) Attach four Olympic Sleeves (#59) to the Posts. Attach a Spring Clip (#76) to each Sleeve.
E.) Insert the Left & Right Bar Holders (#28 & #29), Left & Right Safety Catches (#30 & #31) into
the selected holes on the two Front Vertical Beams (#16).
13