Integra DTM-5.3 - Manual (Page 21)

21
Receiving stations
Listening to stereo radio stations (FM only)
If you tune in a stereo FM station, the STEREO indicator will be
illuminated if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune in the desired
station. In this case, tune as follows:
Press the FM Mode button. FM MUTE OFF lights up. At this time,
the station will be received in mono and noise will be heard.
Select the station to which you wish to listen.
If the MONO indicator lights up while a station is tuned in, the sta-
tion will be received in mono even if it is a stereo station.
You can change the STEREO MODE AUTO/MONO settings by
pressing the FM MODE button.
Programming radio stations
A total of 40 stations can be stored in the memory.
1 Select the frequency that you wish to store in memory.
(Refer to “Tuning the radio” on page 20.)
2 Press the Memory button.
The MEMORY indicator will light for 8 seconds.
3 Select the desired memory number using the number
buttons.
Press button 0/10 when choosing memory number 10.
E.g.:
Standby/On
Speakers
A B
Phones Bass Treble Balance
L R
Master Volume
Video Tape 2 Monitor Tape 1 FM AM Phono CD DVD
Zone 2 Off Memory
Clear
Character Direct Tuning FM Mode Display
Standby
DTM-5.3
1 ABC 2 DEF 3 GHI
4 JKL 5 MNO 6 PQR
7 STU 8 VWX 9 YZ-
Direct Tuning 0/10 / Scan
FM Mode
Memory
Number buttons
FM Mode
RCVR/Tape
Memory
Number
buttons
Memory
Clear
FM Mode
FM MUTE
OFF
STEREO
MODE
AUTO
MONO
STEREO
MODE
FM MUTE TUNED
ON STEREO
AUTO
MONO MONO
MHz CH
FM MUTE TUNED MEMORY
ON STEREO
MHz CH
Memory
Clear
FM Mode
FM MUTE TUNED
ON STEREO
MHz CH
1 ABC 2 DEF 3 GHI
4 JKL 5 MNO 6 PQR
7 STU 8 VWX 9 YZ-
0/10 /
1 ABC
2 DEF
5 MNO
0/10 /
15:
20: