Integra DTM-5.3 - Manual (Page 20)

20
Receiving stations
Tuning the radio (Manual tuning)
When the frequency is not known (Manual tuning)
1 Press the FM or AM button.
2 Use the Tuning buttons (or Tuning Down and Up
buttons on the remote controller) to change the fre-
quency.
(Up).....the frequency increases.
(Down).....the frequency decreases.
• The frequency is changed in 100 kHz steps in FM and
10 kHz in AM each time a tuning selector button is pressed.
• If a button is held continuously for more than 0.5 seconds,
the frequencies are scanned automatically (FM auto tuning
mode). When a broadcast is received, scanning stops.
Tuning the radio (Direct tuning)
When the frequency is known (Direct tuning)
1 Press the FM or AM button.
2 Press the Direct Tuning button (or DRCT Tune button on
the remote controller).
The “-- --” will flash for 16 seconds in the frequency display.
3 Enter the frequency by pressing the number buttons
while the cursors are flashing.
Example: 88.1MHz 8
➔ 8 ➔ 1
• If you enter a frequency that is out of range, the unit will return
to the previous frequency. If this happens, repeat the procedure.
Standby/On
Speakers
A B
Phones Bass Treble Balance
L R
Master Volume
Video Tape 2 Monitor Tape 1 FM AM Phono CD DVD
Zone 2 Off Memory Clear Character Direct Tuning FM Mode Display
Standby
DTM-5.3
1 ABC 2 DEF 3 GHI
4 JKL 5 MNO 6 PQR
7 STU 8 VWX 9 YZ-
Direct Tuning 0/10 / Scan
AM Direct Tuning FM
Tuning
Number buttons
Number
buttons
RCVR/Tape
Tuning
Up Tuning
Down
DRCT
Tune
AM FM
Please make sure that the and AUDIO MUTE indicators are not lit.
For the remote controller, press the RCVR/Tape mode button before performing the
procedure in this section.
T-2 MONITOR
or
FM AM
Tuning
FM MUTE TUNED
ON STEREO
MHz CH
TUNED
CH
kHz
or
FM AM
FM MUTE TUNED
ON STEREO
MHz CH
Direct Tuning
FM MUTE TUNED
ON STEREO
MHz CH
1 ABC 2 DEF 3 GHI
4 JKL 5 MNO 6 PQR
7 STU 8 VWX 9 YZ-
0/10 /
FM MUTE TUNED
ON STEREO
MHz CH