MITSUBISHI ELECTRIC LT-40133 - Manual (Page 21)

3. TV Connections 21
Direct Cable (no cable box)
It is very important to connect the incoming Cable-TV
cable directly (no cable box) to
ANT 1/MAIN.
1. Connect the primary incoming coaxial lead cable to
ANT 1/MAIN on the TV back panel #2.
2. For an optional secondary antenna source, connect
an antenna (or cable) to ANT 2/AUX.
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
065165
*3&.*55&3 %*(*5"-
"6%*0 "/5."*/
57#BDL1BOFM
Figure 4. Wall Outlet Direct Cable
Antenna with a Single Lead
A. For an antenna with flat twin leads
Required: 300-ohm-to-75-ohm transformer.
A1. For an antenna with flat twin leads, connect the
300-ohm twin leads to the 300-ohm-to-75-ohm
transformer.
A2. Push the 75-ohm side of the transformer onto
ANT 1/MAIN on the TV back panel #2.
B. For cable or antenna with coaxial lead
Connect the coaxial lead directly to ANT 1/MAIN on
the TV back panel #2.
Antennas with Separate UHF and
VHF Leads
Required: UHF/VHF combiner
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT 1/MAIN on the TV
back panel #2.
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
065165
%*(*5"-
"6%*0 *3&.*55&3 "/5."*/
#BDL
7JFX 4JEF
7JFX
6)'"OUFOOB
$IBOOFMT
7)'"OUFOOB
$IBOOFMT
0INUP
0IN
$PNCJOFS
'MBU5XJO-FBE
6)'
7)' 5P"/5."*/
57#BDL1BOFM
&YUFSOBM
"OUFOOB
PS$BCMF
Figure 5. Connecting separate UHF and VHF Antennas
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
065165
*3&.*55&3 %*(*5"-
"6%*0 "/5."*/
0IN
'MBU
5XJO-FBE
0QUJPOBM0INUP0IN
.BUDIJOH5SBOTGPSNFS
0IN
$PBYJBM
$BCMF
#
"
"
57#BDL1BOFM
Figure 6. Connecting a Single Antenna Lead
Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.