MITSUBISHI ELECTRIC LT-40133 - Manual (Page 25)

3. TV Connections 25
Older Cable Box
Required: 3 coaxial cables, one two-way RF splitter.
These are not included with the TV.
Note: This connection is not recommended. The
other connections described in this chapter
provide better quality audio and video to the TV
and allow NetCommand to work with cable box.
1. Connect the incoming cable to IN on cable box.
2. Connect one coaxial cable from OUT on the cable
box to ANT 1/MAIN on the TV back panel #2.
065165
*3&.*55&3 %*(*5"-
"6%*0 "/5."*/
"!#+
065165
*3&.*55&3 %*(*5"-
"6%*0 "/5."*/
065
*/
$BCMF#PY 5P"/5."*/
57#BDL1BOFM
Figure 12. Connecting an older cable box
A/V Receiver (Sound System)
Most setups require either a digital audio cable or
analog stereo audio cables.
The TV makes all audio available in digital and analog
formats:
Analog audio coming into the TV is available as
output in digital stereo format on the DIGITAL
AUDIO OUTPUT jack (TV back panel #2).
Digital incoming audio is available as analog
output on the AVR AUDIO OUTPUT, L and R
jacks (TV back panel #1).
Usually, only one of the following connections is
required:
• To connect an analog A/V receiver
Connect left (white) and right (red) audio cables
from
AVR AUDIO OUTPUT, L and R on the TV back
panel #1 to the TV AUDIO INPUT on the A/V receiver.
• To connect a digital A/V receiver with Dolby
Digital surround sound and PCM audio support:
Connect one end of the digital audio cable to
DIGITAL AUDIO OUTPUT on the back of the TV
(back panel #2). Connect the other end to the
COAXIAL DIGITAL INPUT on the back of the A/V
receiver.
065165
*3&.*55&3 %*(*5"- "6%*0 "/5."*/
*/165
47*%&0
7*%&0
-
.0/0
3
3
3
:
1C
1S
3
-
-
.0/0
-
.0/0
"73065
%7**/
"6%*0
$0.10/&/5
*/1654
"73
"6%*0065165
1$%7*
"6%*0*/165
$0.10/&/5
*/1654
JQQJ
"!#+
065165
*3&.*55&3 %*(*5"- "6%*0 "/5."*/
%JHJUBM$PBYJBM$BCMF
6TFUPDPOOFDUB
EJHJUBM"7SFDFJWFS
4UFSFP"OBMPH$BCMFT
6TFUPDPOOFDUBO
BOBMPH"7SFDFJWFS
57#BDL1BOFM
57#BDL1BOFM
Figure 11. Connecting the TV to an A/V receiver
Note:
On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from
the TV as a digital signal. To hear these copy-
protected signals through the A/V receiver, use
connections for analog A/V receivers.
Check the A/V receiver’s Owner’s Guide for
information concerning use of the digital input
and switching between digital sound and
analog stereo sound from the TV.
IMPORTANT
If your A/V receiver has an HDMI input, use
one of the audio connections described here
instead of an HDMI connection.