Millennium Enterprises Integrated Modeling Amplifier - Manual (Page 35)

4. Once the Noise gate type and position are selected use the knob and turn to page 3 of the Noise gate edit module. This page is
used to set the Threshold, Attenuation, Attack and Release parameters. Higher Threshold settings will close the gate sooner. Lower Release
settings allow the gate to open up faster
5. To exit Noise gate edit mode, press the button.
Selecting Effect Configuration Routes
Within every preset of the Millennium, you have the option of selecting any 1 of the 15 Effect Configuration routes available in the Millennium.
This can be very helpful when you have a preset that uses an Amplifier model that you prefer, but the currently selected effect configuration is
not ideal for the digital effects that you wish to use in the preset. You can easily change these Effect configurations by using the following
procedure as a guide:
1. Accessing the effect configurations can be done one of two ways. From Preset mode, simply press the button, or press the
button and use the and turn until the display appears something like this:
Note that the effect configuration is flashing
2. Now use the <1> knob to select any one of the 15 different configurations available.
3. Once the configuration has been selected, press the button to save any changes.
4. To Exit the configuration menu, just press the button to return to preset mode.
A complete listing of the effect configurations of the MIllennium can be found on page 85.
FX Edit Mode
1. From Preset mode, press the button. The display appears something like this:
Wah Pedal Toe Heavy
2
USER
byp 1
CHANGED LINK
1 2
CHANGED LINK CHANGED LINK
1 4
CHANGED LINK
PAGE
1
OF
1
WAH TUBE EQ L/R OUTS
DIGITAL
#
b
GATE
BANK
Config: Series 4,4,4,4
2
USER
1 1
CHANGED LINK CHANGED LINK CHANGED LINK CHANGED LINK
PAGE
1
OF
2
WAH TUBE EQ L/R OUTS
DIGITAL
#
b
GATE
BANK
Johnson Millennium
User Guide
Section - 3 Editing Presets
27