Moxa Technologies NPort 5600 - Manual (Page 67)

NPort 5600 Series User’s Manual Configuring NPort Administrator
5-37
Monitor Async-Settings
Click Async Setting under Monitor to show the run-time settings for each of the four serial ports.
Change Password
Input the “Old password” and “New password” to change the password. Leave the password boxes
blank to erase the password. In this case, the NPort will not have password protection.
ATTENTION
If you forget the password, the ONLY way to configure NPort is by using the Reset button on
NPort’s casing to Load Factory Defaults.
Remember to export the configuration file using Windows Administrator when you finish the
configuration. By using the Import function of Windows Administrator, your configuration can
be re-loaded into NPort after resetting the parameters to their factory defaults. Refer to Chapter 6
for more details about the Export and Import function.