Moxa Technologies NPort 5600 - Manual (Page 61)

NPort 5600 Series User’s Manual Configuring NPort Administrator
5-31
Incoming PAP check
Setting Factory Default Necessity
Yes or No No Optional
Depends on whether the remote user's application requests PAP check.
Source IP address
Setting Factory Default Necessity
Source IP address Required
Destination IP address
Setting Factory Default Necessity
Destination IP address Required
Designation IP address is IP address of remote dial-in server.
IP netmask
Setting Factory Default Necessity
IP netmask Optional
NPort 5600 automatically assigns the netmask 255.255.255.255. We recommend leaving this space
blank.
Modem Initial stream
Setting Factory Default Necessity
Modem Initial stream AT Optional
Accessible IP Settings
NPort has an IP address based filtering method to control access to itself.
Accessible IP Settings allows you to add or block remote host IP addresses to prevent
unauthorized access. Access to NPort is controlled by IP address. That is, if a host’s IP address is
in the accessible IP table, then the host will be allowed to access the NPort. You can allow one of
the following cases by setting the parameter.