Moxa Technologies NPort 5600 - Manual (Page 39)

NPort 5600 Series User’s Manual Configuring NPort Administrator
5-9
Serial Settings
Click Serial Settings, located under Main Menu, to display serial port settings for ports 1 and 2.
NOTE: Since this figure was borrowed from the manual of NPort 5200, which has only 2 RS-232
ports, there are only 2 ports shown in this figure. Once you have completed the hardware
installation of NPort 5600, there should be either 16 or 8 ports shown in the figure, depending on
the model you installed. The steps for changing the settings of the other ports are the same as those
for Port 1 and Port 2.
To modify serial settings for a particular port, click either Port 1 or Port 2 under Serial Settings,
located under Main Menu on the left side of the browser window
Port alias
Setting Factory Default Necessity
1 to 15 characters
(E.g., PLC-No.1)
None Optional
“Port Alias” is specially designed to allow easy identification of the serial devices which are
connected to NPort’s serial port.