Moxa Technologies NPort 5600 - Manual (Page 53)

NPort 5600 Series User’s Manual Configuring NPort Administrator
5-23
UDP Mode
Packing length
Setting Factory Default Necessity
0 to 1024 0 Required
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If
the data length (in bytes) matches the configured value, the data will be forced out. The data length
can be configured for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting Factory Default Necessity
00 to FF None Optional
Delimiter 2
Setting Factory Default Necessity
00 to FF None Optional
Once the NPort receives both delimiters through its serial port, it immediately packs all data
currently in its buffer and sends it to the NPort’s Ethernet port.
Delimiter process
Setting Factory Default Necessity
Do nothing, Delimiter + 1, Delimiter +
2, Strip Delimiter
Do Nothing Required
When [Delimiter + 1] or [Delimiter + 2] is selected, the data will be transmitted when an
additional byte (for Delimiter +1), or an additional 2 bytes (for Delimiter +2) of data is received
after receiving the Delimiter.
When [Strip Delimiter] is selected, when the Delimiter is received, the Delimiter is deleted (i.e.,
stripped), and the remaining data is transmitted.
When [Do nothing] is selected, the data will be transmitted when the Delimiter is received.