Tv back panel, Ant 1/main, ant 2/aux (antenna), Digital audio output – MITSUBISHI ELECTRIC WD-57833 User Manual
Page 9: Rs-232c, Ir emitter netcommand, Ieee 1394 (also known as firewire, Input (audio and video; front and rear), Television overview
1. Television Overview
9
TV Back Panel
1. ANT 1/MAIN, ANT 2/AUX (Antenna)
If you are connecting an antenna or direct cable without
a cable box, connect the main antenna or cable source
to
ANT 1/MAIN. Use ANT 2/AUX for a second source.
ANT 1/MAIN and ANT 2/AUX can each receive digital
and analog over-the-air channels from a VHF/UHF
antenna or non-scrambled digital/analog cable source.
2. DIGITAL AUDIO OUTPUT
This output sends Dolby Digital or PCM digital audio to
your digital A/V surround sound receiver. Analog audio
from analog channels and devices is converted by the TV
to PCM digital audio. If you have a digital A/V receiver,
in most cases this is the only audio connection needed
between the TV and your A/V receiver.
3. RS-232C
Use the RS-232C interface to receive control signals
from compatible home-theater control devices.
4. IR Emitter NetCommand
IR Emitters connected to this jack are used by the TV’s
NetCommand system to control external IR remote
controlled analog devices such as cable boxes, VCRs,
DVDs, satellite receivers and audio receivers.
5. IEEE 1394 (also known as Firewire
®
)
These jacks allow the TV to connect to external IEEE
1394 digital products by means of a single cable. See
chapter 6, “NetCommand” for information regarding
IEEE 1394 connections and recording.
6. INPUT (audio and video; front and rear)
INPUT jacks can be used to connect a VCR, Super VHS
(S-VHS) VCR, DVD player, standard satellite receiver, or
other A/V device to the TV. The
INPUT groups on the
back of the TV consist of jacks for composite video,
S-Video, and analog stereo audio. Note that when you
connect to the S-video jack, the composite video jack
is automatically disabled.
INPUT 3 is a third set of com-
posite video and stereo audio jacks located on the front
of the TV for convenience.
COMPONENT 1
Y Pb Pr (480i/480p/720p/1080i)
COMPONENT 2
RECORD
OUTPUT
OUTPUT
DIGITAL
IR EMITTER
NetCommand
RS-232C
AUDIO
INPUT 1
INPUT 2
HDMI
VIDEO: 480i / 480p / 720p /
1080i / 1080p
W-SVGA, XGA, W-XGA,
AUDIO: LINEAR PCM
PC: VGA, W-VGA, SVGA,
1
(LEFT)
,
, 2
(MIDDLE)
3
(RIGHT)
DVI / PC
VIDEO
AUDIO-
AUDIO-
RIGHT
LEFT
L (MONO)
INPUT
AVR
AUDIO
AUDIO
OUTPUT
S-VIDEO
VIDEO
- AUDIO - R
L (MONO)- AUDIO - R
Y
Pb
Pr
EMITTER
3D GLASSES
SXGA / 720p / 1080p
IEEE 1394
ANT 2 / AUX
ANT 1 / MAIN
1
7
8
2
3
4
5
6
9
11
12
10