MITSUBISHI ELECTRIC WD-57833 - Manual (Page 21)

3. TV Connections 21
Figure 9. Connecting a VCR to an Antenna or Wall Outlet Cable
065
7*%&0
065
7*%&0
*/
*ODPNJOH
$BCMF
"6%*0
065
"6%*0
*/
*/
"/5&//"
-
-
3
3
COMPONENT 1
Y Pb Pr (480i/480p/720p/1080i)
COMPONENT 2
RECORD
OUTPUT
OUTPUT
DIGITAL
IR EMITTER
NetCommand
RS-232C
AUDIO
INPUT 1
INPUT 2
HDMI
VIDEO: 480i / 480p / 720p /
1080i / 1080p
W-SVGA, XGA, W-XGA,
AUDIO: LINEAR PCM
PC: VGA, W-VGA, SVGA,
1 (LEFT) , , 2 (MIDDLE) 3 (RIGHT)
DVI / PC
VIDEO
AUDIO-
AUDIO-
RIGHT
LEFT
L (MONO)
INPUT
AVR
AUDIO
AUDIO
OUTPUT
S-VIDEO VIDEO - AUDIO - R
L (MONO)- AUDIO - R Y Pb Pr
EMITTER
3D GLASSES
SXGA / 720p / 1080p
IEEE 1394
ANT 2 / AUX
ANT 1 / MAIN
RECORD
OUTPUT
AUDIO-
AUDIO-
RIGHT
INPUT 2
L (MONO) S-VIDEO VIDEO - AUDIO - R
LEFT
ANT 1 / MAIN
*/
065 065
B
B
C
C
VCR to an Antenna or Wall Outlet Cable
Required: Two-way RF splitter, two coaxial cables, right
and left analog audio cables, either S-video or video
cable.
1. Connect the incoming cable or antenna to IN on the
RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT 1/MAIN on the TV back panel. This
connection also allows you to use the TV Guide On
Screen and Split Screen features.
4. To use the TV speakers with the VCR, connect left
(white) and right (red) audio cables from AUDIO OUT
on the VCR to INPUT AUDIO L (MONO) and AUDIO
RIGHT on the TV back panel. If your VCR is mono
(non-stereo), connect only the white (left) cable.
5. Connect either an S-Video or composite video
cable from VIDEO OUT on the VCR back panel to
INPUT VIDEO or S-VIDEO on the TV back panel.
Connect only one type of video cable; S-Video is
recommended, if available.
Optional
Perform these two additional steps to:
• Use the TV Guide On Screen recording feature
• Record high-definition digital channels con-
verted to analog standard-definition video and
analog stereo audio
6. Connect left (white) and right (red) audio cables
from AUDIO IN on the VCR to RECORD OUTPUT
AUDIO LEFT and AUDIO RIGHT on the TV back
panel. If your VCR is mono (non-stereo), connect
only the white (left) cable.
7. Connect a composite video cable from VIDEO IN on
the VCR back panel to RECORD OUTPUT VIDEO on
the TV back panel.