MITSUBISHI ELECTRIC LT-55154 - Manual (Page 71)

6. NetCommand Control of an A/V Receiver (265 Series) 71
For assistance call 1(800) 332-2119
Setting Up A/V Receiver Control, continued
NetCommand Control of a Device Con-
nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
You must have already completed the procedure under
“Setup to Control Automatic Audio and Video Switch-
ing via HDMI” on the opposite page. That procedure
placed an icon in the
Input Selection menu for the
device (input) connected to the A/V receiver.
HDMI
Cable
TV
Any Connection
Type
Source
Device
A/V
Receiver
Set up NetCommand control of A/V receiver audio/ 1.
video switching via HDMI as described on the
opposite page.
Press
2. EXIT to close any open menus and return to
normal TV viewing.
Press
3. INPUT.
Highlight the icon for the A/V receiver input you 4.
wish to control.
Press
5. ENTER to switch the TV to the A/V receiver
and the A/V receiver to the input.
Open the
6. Inputs > Learn menu.
Perform NetCommand “learning” for the con- 7.
nected )device by following the steps in “Initial
NetCommand Setup,” page 62.