beautypg.com

Operating netcommand-controlled devices, Netcommand setup, continued – MITSUBISHI ELECTRIC LT-55154 User Manual

Page 63

background image

5. NetCommand IR Control (265 Series)

63

For assistance call 1(800) 332-2119

Operating NetCommand-Controlled
Devices

Controlling Most Device Types

As an example of NetCommand control, if you are
watching your cable box and you wish to tune to the
next channel higher, press

CHANNEL UP. NetCommand

then sends the “learned” channel-up control signal to
the cable box.

Perform NetCommand setup for the device as

1.

described in this chapter.
When you wish to use the device, press

2.

INPUT.

Highlight the icon for the device.

3.

Press

4.

ENTER to switch the TV to the device.

Note: if you have set up automatic input switching for

the A/V receiver, the A/V receiver will automati-
cally switch to the correct input for the device.

To operate the device using the

5.

TV’s remote

control, press the

TV key to put the remote control

into TV mode.
Point the remote control at the

6.

TV (not the device)

and press the key for the desired function.
Press the

7.

TOOLS key to access additional key func-

tions you may have “learned” for the device.

After performing initial setup, you can add or remove
individual keys under NetCommand control.

Switch the TV to the device. Press

1.

INPUT, highlight

the device’s icon, and press

ENTER.

Open the

2.

Inputs menu and highlight the Learn icon.

When the

3.

Learn screen displays:

To add keys:

Continue as described earlier

under “Initial NetCommand Setup” on the
opposite page.
To delete keys:

Highlight the name of the key

you wish to delete and press

CANCEL on the

TV‘s remote control. Clears the check mark.

NetCommand Setup, continued

Adding or Removing Device Keys from
NetCommand Control

This manual is related to the following products: