MITSUBISHI ELECTRIC LT-55154 - Manual (Page 68)

68 6. NetCommand Control of an A/V Receiver (265 Series)
For assistance call 1(800) 332-2119
Setting Up A/V Receiver Control
Power and Volume
Perform this setup to control A/V receiver power and
volume with the TV’s remote control.
To perform this setup you need:
The remote controls for both the TV and the •
A/V receiver.
An IR emitter cable available from Mitsubishi.
•
Before You Begin
Connect your A/V receiver to the TV and any addi- 1.
tional devices.
Connect the IR emitter cable to the TV and position
2.
the IR emitter where it can send signals to the A/V
receiver. See “IR Emitters,” page 61.
Set the
3. TV’s remote control to TV mode.
Setup to Control A/V Receiver Power and Volume
Open the 1. Inputs > AVR menu.
The first function highlighted in the
2. AVR screen is
always Power. Aim the TV’s remote control at the
TV and press ENTER to begin learning for Power.
Inputs > AVR screen. Perform
NetCommand IR “learning” for A/V
receiver power and volume keys.
When the 3. Power text starts flashing, aim the A/V
receiver’s remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to
Power.
If the text stops flashing before the check mark •
appears, repeat this step.
To remove the key from NetCommand control, •
press the CANCEL key while the key name is
highlighted.
Press the 4. key on the TV’s remote control to highlight
other keys in the list. Repeat steps 2 and 3 for each
additional function you wish to control through NetCom-
mand.
If the A/V receiver has a separate
5. POWER OFF key,
press on the TV’s remote to highlight Power
Off. Repeat steps 2 and 3 to “learn” the POWER OFF
key.
If the device has no POWER OFF key, skip this
step.
When finished “learning” the power and volume
6.
keys, press EXIT to watch TV or continue
NetCommand setup if using an HDMI connection.
See “Automatic Audio/Video Switching Over an
HDMI Connection” on the opposite page