beautypg.com

Rear panel – Milan Technology MIL-W0311 User Manual

Page 8

background image

Introduction

5

Wireless

On - Wireless connection available; Wireless Access Point is ready for
use.

Off - No Wireless connection available.

Flashing - Data is transmitted or received via the Wireless access point.
This includes "network traffic" as well as user data.

Print Error

On - Printer error detected.

Off - No printer error detected.

Print Act

On - Connection to printer established.

Off - No connection to printer; printer is Off or Off-line.

Flashing - Data is being transmitted to the printer.

COM

(Serial Port)

Off - Idle or no active device connected to the serial (RS232) port.

Flashing - Data is transmitted or received via the serial (RS232) port.

Rear Panel

Figure 2: Rear Panel

Serial Port

RS232 Serial Port. If you have an analog modem or ISDN TA,
connect it here.

Printer Port

Standard parallel printer port. If you wish to share a printer, connect it
here.

WAN port
(10BaseT)

Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.

DIP switches

Refer to the following table.

PC port
(10/100BaseT)

If connecting directly to your PC (no Hub) use this port and a stan-
dard LAN cable (RJ45 connectors).

Use EITHER the PC port OR the Hub port, NOT both.

HUB port
(10/100BaseT)

Use a standard LAN cable (RJ45 connectors) to connect this port to a
10BaseT or 100BaseT hub.
Use EITHER the PC port OR the Hub port, NOT both.

This manual is related to the following products: