Milan Technology MIL-W0311 - Manual (Page 38)

PC Configuration
35
Dial-in Configuration
This section describes how to configure your PC to use the Wireless Gateway's RAS Dial-in
feature.
To use the RAS Dial-in feature of the Wireless Gateway:
• An Analog Modem or ISDN TA must be connected to the Serial Port on the Wireless
Gateway.
• The Wireless Gateway's Serial Port screen must be configured for Dial-in access, and
Dial-in Users must be created. See Chapter 6 - Serial Port for details.
• A suitable Dial-up connection must be created on your PC, as described below.
Creating a Dial-in Connection in Windows
You can use the standard Windows Dial-up Networking software normally used for Internet
access. The procedure is as follows:
1. Ensure your modem is installed and working.
2. Select My Computer, then Dial-up Networking.
3. Click Make new Connection, and step through the Wizard.
• Give this connection a suitable name.
• Enter the area code and telephone number to connect to the Wireless Gateway.
• Continue the Wizard until completed.
4. The default values for this connection will work with the Wireless Gateway's default
values. If necessary, you can adjust the Properties for the connection:
• In the Dial-up Networking window, select the connection.
• Right-click, and select Properties to see a screen like the one below.
Figure 18: Dial-up Networking Properties