Mercedes-Benz 2004 ML 500 - Manual (Page 145)

145
Controls in detail
Power windows
Opening the windows
̈ Press switch 1 to 4 at the
symbol
k to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Press switch 1 to 4 at the
symbol
j to the resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 at the
symbol
k past the resistance point
and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Press switch 1 to 4 at symbol j
past the resistance point and release.
The corresponding window closes com-
pletely.
Stopping windows
̈ Press respective switch again.
Warning
G
If you pull and hold the switch up when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands, fin-
gers, etc., the automatic reversal will not op-
erate.
!
If the upward movement of the window
is blocked during the closing proce-
dure, the window will stop and open
slightly.
Remove the obstruction, press the
switch
j again past the resistance
point and release.
If the window still does not close when
there is no obstruction, then hold the
switch
j down. The side window
will then close without the obstruction
sensor function.
Warning!
G
Driver’s door only:
If within five seconds switch
j is again
pressed past the resistance point and
released, the automatic reversal will not
operate.