Chapter 5: configure net101 by web browser – Mega System Tech RS485 User Manual
Page 15
NET101 User’s Manual -13-
Chapter 5: NET101 Web Manager
Chapter 5: Configure NET101 by WEB Browser
Section 1. Introduction
After you have setup the hardware and set an IP address for NET101, you will then be
able to go to NET101 web site to monitor, manage and control the serial devices. All
you have to do is enter the new IP address into any standard web browser.
To do this;
1. Start the Web Brower (Netscape or Internet Explore)
2. Enter NET101 IP Address that was set earlier using Netility (e.g. 211.21.67.51)
and press [ENTER]
Fig.15 Enter NET101 IP address
3. A login screen will appear, press [ENTER]. By default the username and
password is left blank.
Fig.16 NET101 Login screen
Section 2. NET101 Web Manager Interface
NET101 webpage main menu is divided into two sections. The selections menu on
the left and display menu on the right. The selection menu consists of the following
options:
2.1 Information
2.2 Configuration
2.3 Help