Marantz R3001 - Manual (Page 39)

35
ENGLISH
TECHNICAL
SPECIFICATIONS
FM TUNER SECTION
Frequency Range .................................87.5 - 108.0 MHz
Usable Sensitivity ............................IHF 1.8 µV/16.4 dBf
Signal to Noise Ratio ................... Mono/Stereo 75/70 dB
Distortion ......................................Mono/Stereo 0.2/0.3 %
Stereo Separation .........................................1 kHz 45 dB
Alternate Channel Selectivity .................± 300 kHz 60 dB
Image Rejection .........................................98 MHz 70 dB
Tuner Output Level ........... 1 kHz, ± 75 kHz Dev 800 mV
AM TUNER SECTION
Frequency Range .................................... 531 - 1602 kHz
Signal to Noise Ratio .............................................. 50 dB
Usable Sensitivity .................................... Loop 400mV/m
Distortion ...................................400Hz, 30 % Mod. 0.5 %
Selectivity .................................................± 18 kHz 70 dB
AUDIO SECTION
Power Output (20 Hz - 20 kHz/THD=0.08%)
Front L&R ............................................8 ohms 60 W / Ch
Center ..................................................8 ohms 60 W / Ch
Surround L&R ......................................8 ohms 60 W / Ch
Surround Back L&R .............................8 ohms 60 W / Ch
Front L&R ............................................6 ohms 75 W / Ch
Center ..................................................6 ohms 75 W / Ch
Surround L&R ......................................6 ohms 75 W / Ch
Surround Back L&R .............................6 ohms 75 W / Ch
Input Sensitivity/Impedance ...............168 mV/ 47 Kohms
Signal to Noise Ratio(Analog Input / Pure Direct) .... 105 dB
Frequency Response
(Analog Input / Pure Direct)
............................................8 Hz - 100 kHz (± 3 dB)
(Digital Input / 96 kHz PCM)
............................................. 8 Hz - 45 kHz (± 3 dB)
VIDEO
Television Format ....................................................... PAL
Input Level/Impedance ........................... 1 Vp-p/75 ohms
Output Level/Impedance ......................... 1 Vp-p/75 ohms
Video Frequency Response .......5 Hz to 8 MHz (– 1 dB)
Video Frequency (Component) ....5 Hz to 80 MHz (– 1 dB)
S/N .......................................................................... 60 dB
GENERAL
Power Requirement ...........................AC 230 V 50/60 Hz
Power Consumption .............................................. 370 W
Weight ................................................................. 11.1 Kg
ACCESSORIES
Remote Control Unit RC5500SR ................................... 1
AAA-size batteries ........................................................ 2
FM Antenna ................................................................... 1
AM Loop Antenna .......................................................... 1
Specifi cations subject to change without prior notice.
GENERAL MALFUNCTION
If the equipment malfunctions, this may be because
an electrostatic discharge or AC line interference has
corrupted the information in the equipment memory
circuits. Therefore:
- disconnect the plug from the AC line supply
- after waiting at least three minutes, reconnect
the plug to the AC line supply
- re-attempt to operate the equipment
Memory backup
• In case a power outage occurs or the power
cord is accidentally unplugged, the SR3001
is equipped with a backup function to prevent
memory data such as the preset memory from
being erased.
HOW TO RESET THE UNIT
SURROUND
AV SURROUND RECEIVER SR3001
DOWN UP
VOLUME INPUT SELECTOR
POWER ON/OFF PHONES
STANDBY
MUTE 7.1CH INPUT S. SPEAKER B ATT PURE SETUP DIRECT SIMPLE
AUTO HT-EQ MENU ENTER
DISPLAY MEMORY CLEAR
T-MODE EXIT BAND
MODE
DISP MULTI AUTO TUNED ST V – OFF NIGHT PEAK ANALOG DIGITAL ATT SLEEP SURR AUTO DIRECT DISC 6.1 MT X 6.1 EQ DIGITAL SURROUND
AAC PCM L C R SL S SR LFE
Should the operation or display seem to be abnormal,
reset the unit with the following procedure.
The SR3001 is turned on, press and hold the
7.1CH INPUT and ATT buttons simultaneously for 3
seconds or more.
Remember that the procedure will reset the settings
of the function selector, Surround mode, delay time,
TUNER PRESET etc., to their initial settings.
SURROUND
AV SURROUND RECEIVER SR3001
DOWN UP
VOLUME INPUT SELECTOR
POWER ON/OFF PHONES
STANDBY
MUTE 7.1CH INPUT S. SPEAKER B ATT PURE SETUP DIRECT SIMPLE
AUTO HT-EQ MENU ENTER
DISPLAY MEMORY CLEAR
T-MODE EXIT BAND
MODE
DISP MULTI AUTO TUNED ST V – OFF NIGHT PEAK ANALOG DIGITAL ATT SLEEP SURR AUTO DIRECT DISC 6.1 MT X 6.1 EQ DIGITAL SURROUND
PCM L C R SL S SR LFE
16.
3
mm
146 mm
440 mm
20 mm
25 mm
3
42.5 mm 38
7.5 mm
162.
3
mm
DIMENSIONS