Middleby Cooking Systems Group PS536 User Manual

Page 6

ENGLISH

SECTION 2 - INSTALLATION

WARNING

Keep the appliance area free and clear of combustibles.

WARNING

Do not obstruct the flow of combustion and ventilation air to and from your oven. There must be no

obstructions around or underneath the oven. Constructional changes to the area where the oven is

installed shall not affect the air supply to the oven.

CAUTION

For additional installation information, contact your local Authorized Service Agent.

NOTE

There must be adequate clearance between the oven and combustible construction. Clearance

must also be provided for servicing and for proper operation.

NOTE

An electrical wiring diagram for the oven is located inside the machinery compartment.

NOTE

All aspects of the oven installation, including placement, utility connections, and ventilation requirements,

must conform with any applicable local, national, or international codes. These codes supercede the require-

ments and guidelines provided in this manual.

WARNING

The oven must be installed on an even (level) non-flammable flooring and any adjacent walls must

be non-flammable. Recommended minimum clearances are specified in the Description section of

this Manual.

WARNING -

For gas ovens, after any conversions, readjustments, or service work on the oven:

Perform a gas leak test.

Test for correct air supply.

Test for proper combustion and gas supply.

Check that the ventilation system is in operation.

NOTE

In the USA, the oven installation must conform with local codes. In the absence of local codes, gas oven

installations must conform with the National Fuel Gas Code, ANSI Z223.1. Gas and electric ovens, when

installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with

the National Electrical Code (NEC), or ANSI/NFPA70.

NOTE

In Canada, the oven installation must conform with local codes. In the absence of local codes, gas oven

installations must conform with the Natural Gas Installation Code, CAN/CGA-B149.1, or the Propane Gas

Installation Code, CAN/CGA-B149.2, as applicable. Gas and electric ovens, when installed, must be electri-

cally grounded in accordance with local codes, or in the absence of local codes, with the Canadian Electrical

Code CSA C22.2.

NOTE

In Australia, the oven installation must conform with any requirements of the appropriate statutory authority.

Gas oven installtions must conform with AGA Code, AG601.

WARNING

For electric ovens, after any conversions, readjustments, or service work on the oven, check that the

ventilation system (if so equipped) is in operation.