Middleby Cooking Systems Group PS536 - Manual (Page 17)

17
ENGLISH
B. DAILY SHUTDOWN PROCEDURE
SECTION 3 - OPERATION
1. Turn the "BLOWER" ( )
and "CONVEYOR" ( )
switches to the "OFF"
("O") position. Open the
window (if so equipped)
to allow the oven to cool
faster.
Note that the blowers will
remain in operation until
the oven has cooled to
below 200°F (93°C).
3. After the oven has cooled and the blowers are off, switch the
circuit breaker/fused disconnect to the off position.
IMPORTANT
On gas ovens, if the "HEAT ON" light will not illuminate, OR
if the oven does not heat, the gas burner may not have lit.
Turn the "BLOWER"
( ) and "CONVEYOR" ( ) switches
to the "OFF" ("O") position. Wait for AT LEAST FIVE MIN-
UTES before restarting the oven. Then, repeat the Daily
Startup procedure.
CAUTION
In case of power failure, turn all switches to the “OFF” ("O")
position, open the oven window (if so equipped), and
remove the product. After the power has been restored,
perform the normal startup procedure. IF THE OVEN WAS
SWITCHED OFF FOR LESS THAN 5 MINUTES, WAIT FOR
AT LEAST FIVE MINUTES BEFORE RESTARTING THE
OVEN.
No attempt should be made to operate the oven during a
power failure. In gas ovens, the burner will not operate
and gas will not flow through the burner without electric
power.
+
6b. Check that the "HEAT ON"
light illuminates. This
shows that the burner or
heating elements have
been turned on.
8b. (Optional) Press the Tem-
perature ( ) key to show
the Actual Temperature
in the display, and wait
for the "ACTUAL TEMP"
light to turn on. This al-
lows you to monitor the
oven temperature as it
rises to the setpoint.
7b. Wait for the oven to heat to the setpoint temperature. Higher
setpoint temperatures will require a longer wait. The oven
can reach a temperature of 500°F (232°C) in approximately
5 minutes.
+
wait
for
• Press the Up Arrow
and Down Arrow
Keys as necessary
to adjust the set-
point.
or
5b. Adjust the temperature
controller to a desired set
temperature, if neces-
sary.
•
Press the Set Point
and Unlock keys at
the same time. Wait
for the "SET PT" light
to turn on.
wait
for
9b. Allow the oven to preheat for 10 minutes after it has reached
the set point temperature.
wait
for
If the oven uses this
Digital Temperature
Controller: