Motorola 3460 Fast'R - Manual (Page 69)

3460 Fast’R
C-5
Table 2-2. Fax Class 2.0 AT Command Set
Command Option Description
+F commands control fax operation.
For fax parameters:
• The AT+F[parameter]? command returns the options for the parameter, or, if the
parameter is not supported, ERROR.
• The AT+F[parameter]=? command returns the current option for the parameter, or, if
the parameter is not supported, ERROR.
• The AT+F[parameter]=[value] command sets the option for the parameter, or, if the
option or parameter is not supported, returns ERROR.
Capabilities Identification and Control Commands
+FCLASS?
or
+FCLASS=? Service Class
Reads the modem’s Service Class.
0 Data modem
1 Service Class 1 fax modem
2.0 Service Class 2.0 fax modem
+FCLASS=n Service Class
Sets the modem’s Service Class.
0 Data modem
1 Service Class 1 fax modem
2.0 Service Class 2.0 fax modem
+FMI? Manufacturer ID
Reads the manufacturer ID from the modem.
The modem responds:
Motorola
+FMM? Modem ID
Reads the modem ID from the modem.
The modem responds:
3460
+FMR? Software Revision Level
Reads the software revision ID from the modem.
The modem responds (example):
4.0
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.