Autoexec.reg, Autoexec.bat, Present. see also chapter – Micro Innovations M000174-19 User Manual
Page 8
General Windows
CE
8
M000174-19
After Windows CE is launched, the following functions are run if the
pressed:
1. The bootloader searches for the AutoLaunch.inf file on the SD Flash card. If this file is present, the
program is started under [AutoLaunchBoot]. See also chapter
2. The registry entries are transferred when the AUTOEXEC.REG file is found in the root directory of
the boot device. See also chapter
.
3. The bootloader also looks for the AUTOEXEC.BAT file in the root directory. This file is run if it is
.
1.2 A
UTOEXEC
.
REG
Customer-specific registry entries can be configured using the AUTOEXEC.REG file when the MICRO
PANEL starts up. The file must be stored in the root directory of the boot device. The registry is used
for different settings (see also chapter
). When the MICRO PANEL is started, the
registry is set according to the image, partly also known as the CE kernel. All other necessary registry
entries must be contained in this file.
The file format is described in the chapter «
».
Note:
The file AUTOEXEC.REG file is not executed if the
is pressed during the
startup!
1.3 A
UTOEXEC
.
BAT
A customized panel start can be implemented with the AUTOEXEC.BAT start file. This enables
command line commands to be executed without a keyboard. The file must be stored in the root
directory of the device. A search is carried out for the «Autoexec.bat» file for 10 seconds after the
operating system is started. If the file is found, it is executed using a «CMD» Shell. The «CMD» Shell
is given a parameter (%1) for the AUTOEXEC.BAT file with the name of the boot device. This
parameter can be used to start programs from the correct device:
Note:
The file AUTOEXEC.REG file is not executed if the
is pressed during the
startup!
Important:
If a download is executed with the GALILEO Design Tool, the AUTOEXEC.BAT file is created again
on the basis of the INI file in the GALILEO project. This means that any required settings must be
added to the INI file. For more information on this refer to the chapter «INI File Startup» in the
GALILEO online documentation.