MITSUBISHI ELECTRIC WD-57831 - Manual (Page 28)

28 Chapter 2. TV Connections
Older Cable Box
Required: 3 coaxial cables, one two-way RF splitter.
These are not included with the TV.
When this setup is complete, you can use the TV remote
control, when programmed, to change channels on the
cable box.
Note: This connection is not recommended. The other
connections described in this chapter provide
better quality audio and video to the TV and allow
NetCommand and TV Guide On Screen to work
with the cable box.
1. Connect the incoming cable to IN on the RF splitter.
2. Connect one coaxial cable from OUT on the RF split-
ter to ANT 1/MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF split-
ter to IN on the standard cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT 2/AUX on the TV back panel.
1$%7*
"6%*0
"6%*0
065
$0.10/&/5
*/165
.0/*503
065
)%.*%7*"6%*0
"/5."*/ "/5"69
*&&& %*(*5"-
"6%*0
065
)%.*
1$%7*
7*%&0
-&'5
3*()5
-&'5
3*()5
:
1C
1S
"6%*0
-&'5
.0/0
"6%*0
3*()5
-&'5
3*()5
64&8*5) $BCMF$"3%™
$BCMF$"3%™ 64&8*5) "/5$"3%501
47*%&0
7*%&0
"6%*0
-&'5
.0/0
"6%*0
3*()5
)%.*$0.1"5*#*-*5:
7*%&0JQQJQ
$0.10/&/5$0.1"5*#*-*5:
7*%&0JQQJ
%7**1$$0.1"5*#*-*5:
3&'&35008/&34(6*%&
TM
R
"/5."*/ "/5"69 64&8*5) $BCMF$"3%™
*/ 065 */ 065
*/
065
065
5808
" :41-*55&3
57CBDLQBOFM
$BCMFCPY
CBDLQBOFM
3'4QMJUUFS
5P"/5."*/ 5P"/5"69
*ODPNJOH
$BCMF
Figure 12. Connecting an older cable box
Camcorder
Required: Analog stereo audio cables and either an
S-Video or composite video cable.
NOTE: For IEEE 1394 camcorders, see also later in this
chapter under “IEEE 1394 Devices.”
1. Connect either an S-Video or composite video cable
from VIDEO OUT on the camcorder to INPUT 3/
VIDEO or S-VIDEO on the TV. Connect only one
type of video cable; S-Video is recommended, if avail-
able.
2. Connect left (white) and right (red) audio cables
from AUDIO OUT on the camcorder to INPUT 3/
AUDIO L and AUDIO R on the TV.
$PNQPTJUF7JEFP$BCMF
47JEFP$BCMF
Figure 13. Analog connections for a camcorder