MTD 5DM - Manual (Page 11)

11
Never:
1. Use when fluid is below 20° F or above 150° F.
2. Operate in FORWARD or REVERSE position with
ram stopped for extended period.
3. Attempt to adjust unloading or relief valve settings.
4. Operate with air in hydraulic system.
5. Use teflon tape on hydraulic fittings.
6. Attempt to cut wood across the grain.
7. Attempt to remove partially split wood from the
wedge with your hands.
Operating Tips
Always:
1. Use clean fluid and check fluid level regularly.
2. Use an approved hydraulic fluid. Approved fluids
include Dexron® III, or a 10 Weight AW hydraulic oil.
3. Keep hoses clear and unblocked.
4. Use the hydraulic valve control to extend and retract
cylinder 4-6 cycles to remove trapped air in the system
before operating.
5. Flush and clean hydraulic system before restarting
after servicing.
6. Use “pipe dope” on all hydraulic fittings.
7. Operate on level ground.
8. Allow time for warm-up before splitting wood.
9. Prime the pump before initial start-up by pulling the
recoil starter on the engine 4-6 times with engine
switch in OFF position and spark plug disconnected.
10. Split wood along the grain (lengthwise) only.
11. Keep log centered in front of ram.
4
Operating
Your Log
Splitter