MGE UPS Systems Switched PDU - Manual (Page 39)

3. Operations
Displaying the firmware version
The Version command displays the firmware version.
To display the firmware version:
At the Switched PDU: prompt, type version and press Enter .
Performing a warm boot
The Restart command performs a warm boot of the Switched PDU.
NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this
command.
To perform a warm boot:
At the Switched PDU: prompt, type restart and press Enter .
TCP/IP Administration
NOTE: A restart of the Switched PDU is required after setting or changing ANY TCP/IP configurations. See
Performing a warm boot for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Switched PDU: prompt, type set ipaddress , followed by the IP address and press Enter .
Example
The following command sets the IP address to 12.34.56.78:
Switched PDU: set ipaddress 12.34.56.78
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.
To set the subnet mask:
At the Switched PDU: prompt, type set subnet , followed by the subnet mask and press Enter .
Example
The following command sets the subnet mask to 255.0.0.0
Switched PDU: set subnet 255.0.0.0
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the Switched PDU uses to access
external networks.
To set the gateway IP address:
At the Switched PDU: prompt, type set gateway , followed by the gateway IP address and press Enter .
Example
The following command set the gateway IP address to 12.34.56.1:
Switched PDU: set gateway 12.34.56.1
301-0399-4 Rev A. - Page 39