MGE UPS Systems Switched PDU - Manual (Page 29)

3. Operations
Administration Commands
Administration commands may only be issued by a user with administrative privileges, such as the predefined
Admn user or another user who has been granted administrative privileges with the Set User Admnpriv
command.
User Administration
Creating a user account
The Create User command creates a user account with the specified username and password. See Usernames
and Passwords in this chapter for more information.
To create a user account:
At the Switched PDU: prompt, type create user , optionally followed by a 1-16 character username (Spaces
are not allowed, and usernames are not case sensitive). Press Enter .
At the Password: prompt, type a password of up to 16 alphanumeric and other typeable characters (ASCII 32 to
126 decimal). Passwords are case sensitive. Press
Enter . To specify no password, press Enter at the
prompt.
At the Verify Password: prompt, retype the password. Press Enter . To verify no password, press Enter at the
prompt.
Example
The following command creates the user account JaneDoe:
Switched PDU: create user JaneDoe
Password:
Verify New Password:
For security, password characters are not displayed.
Removing a user account
The Remove User command removes a user account.
NOTE: You may remove the predefined user account Admn only if another user account has been granted
administrative privileges using the Set User Admnpriv command.
To remove a user account:
At the Switched PDU: prompt, type remove user , optionally followed by a username. Press Enter .
301-0399-4 Rev A. - Page 29