MGE UPS Systems Switched PDU - Manual (Page 35)

3. Operations
Setting the outlet wakeup state
The Set Outlet Wakeup command set the default wakeup state for that outlet. In the event of a system-wide
power loss, this state will be applied to the outlet when power is restored.
The wakeup state may be set to On or Off. Upon restoration of system power; If set to On, the Switched PDU will
apply power to that outlet. If set to Off, the Switched PDU will not apply power to that outlet.
To set the wakeup state:
At the Switched PDU: prompt, type set outlet wakeup , followed by on or off and the outlet name. Press Enter .
Example
The following command sets the wakeup state for outlet .a1 to off:
Switched PDU: set outlet wakeup off .a1
Displaying outlet information
The Show Outlets command displays information about all outlets. This information includes:
• Descriptive outlet name, if applicable
• Outlet wakeup state setting
To display outlet information:
At the Switched PDU: prompt, type show outlets and press Enter .
Example
The following command displays all outlet information:
Switched PDU: show outlets
Outlet Outlet Wakeup
ID Name State
.A1 DataServer_1 off
.A2 WebServer_1 on
.A3 FileServer_1 last
.A4 on
.A5 on
.A6 on
.A7 on
.A8 on
.A9 on
.A10 on
.A11 on
.A12 on
.A13 on
.A14 on
.A15 on
.A16 on
More (Y/es N/o):
301-0399-4 Rev A. - Page 35