MGE UPS Systems Switched PDU - Manual (Page 24)

3. Operations
Operations Commands
Operations commands manage outlet states, provide information about the Switched PDU environment and
control session operations.
NOTE: Users must be granted access to affect any change in outlet state.
Turning outlets on
The On command turns on an outlet or group. When the command completes, a display indicating all outlets
affected and their current states will be displayed.
To turn outlets on:
At the Switched PDU: prompt, type on , followed an outlet, and press Enter , or
Type on , followed by a group name, and press Enter , or
Type on all and press Enter .
Examples
The following command turns the second outlet on, using the outlet ’s absolute name:
Switched PDU: on .a2
The following command turns on all the outlets in the group named ServerGroup_1:
Switched PDU: on ServerGroup_1
Turning outlets off
The Off command turns an outlet or group. When the command completes, a display indicating all outlets
affected and their current states will be displayed.
To turn outlets off:
At the Switched PDU: prompt, type off , followed an outlet, and press Enter , or
Type off , followed by a group name, and press Enter , or
Type off all and press Enter
Examples
The following command turns off the outlet named FileServer_1:
Switched PDU: off FileServer_1
The following command turns off all outlets:
Switched PDU: off all
Rebooting outlets
The Reboot command reboots an outlet or group. This operation turns the outlet(s) off, delays for a period of 15
seconds and then turns the outlet(s) on. When the command completes, a display indicating all outlets affected
and their current states will be displayed.
NOTE: It is necessary to reissue the Status command to verify that the outlets have rebooted after 15 seconds.
See Displaying outlet status for more information.
To reboot one or more outlets:
At the Switched PDU: prompt, type reboot , followed by an outlet, and press Enter , or
Type reboot , followed by a group name, and press Enter , or
Type reboot all and press Enter .
Example
The following command reboots all the outlets in the group named ServerGroup_1:
Switched PDU: reboot ServerGroup_1
Page 24 - 301-0399-4 Rev A.