Miele DG 2351 - Manual (Page 54)

... during operation an unusually
large amount of steam escapes or
steam escapes from parts of the
steam oven where it does not
usually.
Check whether,
– the door is closed properly.
– the door seal is fitted correctly. If
necessary press it in all the way
round the door to make sure it is
fitted evenly.
– the door seal is damaged, e.g.
cracks can be seen. The seal must
be replaced with a new one.
If this does not solve the problem, call
the Miele Service Department.
... the p symbol appears in the
time/temperature display and an
audible tone may sound.
Check whether,
– the water container has been pushed
right into the appliance so that it
connects.
– there is sufficient water in the water
container. The water level must be
between the two markings.
... when the appliance is switched on,
the
k symbol and a number between
1 and 10 appear in the
time/temperature display or the k
symbol is highlighted in the function
display.
The appliance needs to be descaled.
Proceed as described in “Descaling” in
"Cleaning and care".
... the fault message F05 or F06
appears in the time/temperature
display.
Switch the appliance off and call the
Service Department.
... the fault message F20 appears in
the time/temperature display.
The appliance does not heat up.
Check whether the water container has
been pushed right into the appliance so
that it connects.
Switch the appliance off and then back
on again. If the fault occurs several
times, switch the appliance off and call
the Service Department.
... after a period of time, the door
makes a noise when it is opened and
closed.
Lubricate the hinges with the silicone
grease supplied.
Problem solving guide
54