MITSUBISHI ELECTRIC WD-52631 - Manual (Page 83)

Chapter 7. Using IEEE 1394 Devices 83
Recording from the ChannelView™ Channel
Guide
ChannelView provides program listings, as sent by the
broadcasters, for memorized channels on
ANT 1 and
ANT 2. Press the GUIDE key while watching ANT 1 or
ANT 2 to view ChannelView listings and to set up imme-
diate or future recordings as described here.
Immediate Recording from ChannelView
1. Press INPUT to open the Input Selection menu. High-
light an ANT 1 or ANT 2 program source and press
ENTER.
2. Press GUIDE to open the ChannelView channel guide for
the current input.
3. Use to highlight the channel and program you
wish to record from the list of channels.
4. Press (RECORD).
A red “R” temporarily displays next to the program
listing to indicate the program will be recorded.
5. Press EXIT to return to TV viewing.
Time-Delayed Recording from ChannelView
Set Up the Recording
1. Ensure that TV Energy Mode is set to
Fast Power On
and the TV clock is set to the correct time and day.
See “Setup Menu” in chapter 4, “TV Menu Settings.”
2. Perform steps 1 and 2 described above.
3 Press to highlight the source channel you wish to
record from.
4. Press to view a list of future programs on that
channel.
5. Press to highlight a future program.
6. Press
(RECORD).
A red “R” temporarily displays next to the program
listing to indicate the program will be recorded.
You can schedule a maximum of 32 recordings.
7. Press EXIT to close the menu.
Confirm the Recording Setup
1. Press
(RECORD) to open the Record menu.
2. Press GUIDE to open the Record List (figure 2) and view
all scheduled recordings. Press CH / to page
quickly through the list.
3. Verify that the program you wish to record appears in
the list.
4. Press EXIT to close the menu.
Recording to IEEE 1394 Recordable
Devices, continued Cancelling Recordings
To Cancel a Recording in Progress
1. Press INPUT to open the Input Selection menu.
2. Move the highlight to the source input icon. There is
no need to press ENTER.
The Input Selection menu displays an icon for an
active recording connection to a recordable IEEE 1394
device. See the IEEE 1394 connection icon in figure 3.
3. Press CANCEL. The connection icon will disappear to
indicate termination of the recording connection.
4. Press EXIT to return to TV viewing.
Connection
Icon
Audio
Icons
Figure 3. The Input Selection menu displays specialized
icons for IEEE 1394 devices. The audio icons are
displayed only when an IEEE 1394 amplifier is connected.
To Cancel a Scheduled Recording
1. Press (RECORD) to open the Record menu.
2. Press GUIDE to open the Record List (figure 2) and view
all scheduled recordings. Press CH / to page
quickly through the list.
3. Highlight the program you wish to remove from the
Record List and press CANCEL.
4. Press EXIT to close the menu.