beautypg.com

Remote control, continued – MITSUBISHI ELECTRIC WD-52631 User Manual

Page 35

background image

Chapter 3. TV Operation

35

22

28

10

1

2

3

4

7
8
9

24

23

26 27

25

16

17

11

12

13

14
15

5

6

18

19

20

21

Figure 1. Remote Control Overview

Battery Installation

Figure 2

1. Remove the remote control’s back cover by gently

pressing in the tab and lifting off the cover.

2. Load the batteries, making sure the polarities (+) and

(-) are correct. For best results, insert the negative (-)
end first.

3. Snap the cover back in place.

Sleep Timer

Setting the Sleep Timer
1. Press

SLEEP on the remote control.

2. Press

SLEEP additional times to increase the time in

30-minute increments up to the maximum of 120
minutes.

3. Press

EXIT or wait five seconds without pressing any

buttons for the message to disappear.

4. Press

SLEEP to view the time remaining before the sleep

timer turns off the TV.

Cancelling the Sleep Timer
1. Press

SLEEP to display the on-screen message.

2. Press

SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will

disappear.

2

1

Figure 2. The remote control requires two AA alkaline
batteries.

Care

For Best Results from the Remote Control:
• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time unless

instructed to do so.

• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft,

lightly moistened cloth.

• Do not mix old and new batteries.
• Do not heat, take apart, or throw batteries into fire.

Resetting the Remote Control

If the slide switch is set to

TV and the TV does not respond

properly, do the following to reset the remote control.

1. Press and hold

POWER for several seconds until the button

blinks twice and goes off.

2. Release the

POWER button.

3. Press keys

0 0 9 3 5 and the POWER button will blink twice

when you finish entering the code. While entering the
code, pause for a moment between each key press to
ensure it is recognized.

Low-Battery Indicator

If you press a key and the

POWER indicator blinks five times,

replace the remote control’s batteries.

Remote Control, continued

This manual is related to the following products: