Middleby Marshall Model PS536 - Manual (Page 11)

11
ENGLISH
C. Conveyor Installation
PS536 ovens may be equipped with either of two different
conveyor designs. Both designs are available in single belt and
split belt configurations. Refer to Figures 2-9 and 2-10 to
determine which conveyor was shipped with your oven.
Figure 2-9 - Identifying the Type 1 conveyor
Figure 2-10 - Identifying the Type 2 conveyor
Tensioning screws
(2 per side)
Pins on frame
fit into slots
on bracket
Some conveyors MAY be
equipped with external
bearings on drive shaft
Tension adjustment
screws (2) on idler
end of conveyor
Conveyor frame made of
rectangular steel sections
Conveyor frame made of
"C"-section stainless steel
Hinge plates at
center of conveyor
frame
• If your oven uses the Type 1 Conveyor, continue on to Step
1 in this section, "Type 1 Conveyor Installation."
• If your oven uses the Type 2 Conveyor, skip ahead to Step
2 in this section, "Type 2 Conveyor Installation."
SECTION 2 - INSTALLATION