Default rules, Special commands, Pause duration – Motorola LS3578 User Manual
Page 227: Begin new rule, Save rule, Default rules -5, Special commands -5, Pause duration -5, Begin new rule -5 save rule -5, Bar code on
Advanced Data Formatting 12 - 5
Note also that ADF rules are actually created when using the standard data editing functions. Scan options are
entered as ADF rules, and the hierarchy mentioned above also applies to them. For the digital imager scanner, this
applies to prefix/suffix programming in the parameter Scan Data Transmission Format.
These rules reside in the same “rule list” as ADF Rules, so the order of their creation is also important.
Default Rules
Every unit has a default rule to send all scan data. Units with custom software may have one or more default rules
burned in. The rules hierarchy checks user programmable rules first, then the default rules. Default rules can be
disabled by entering the following general rule in the user programmable buffer:
When receiving scan data, send all data.
Since this rule always applies, ADF will never go into the default rules.
Special Commands
Pause Duration
This parameter, along with the Send Pause parameter on
allows a pause to be inserted in the data
transmission. Pauses are set by scanning a two-digit number (i.e., two bar codes), and are measured in 0.1 second
intervals. For example, scanning bar codes “0” and “1” inserts a 0.1 second pause; “0” and “5” inserts a 0.5 second
delay. See
. To correct an error or change a selection, scan
.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Save Rule