Motorola LS3578 - Manual (Page 122)

7 - 4 Symbol LS3578 Product Reference Guide
RS-232 Host Parameters
Various RS-232 host types are set up with their own parameter default settings. Selecting the host type sets the
parameter defaults as listed in
Table 7-2 .
Table 7-2 Terminal Specific RS-232
Parameter
Standard
RS-232
(Default)
ICL
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B
Olivetti Omron
OPOS/
JPOS
Fujitsu
Transmit
Code ID No Yes Yes Yes Yes Yes Yes Yes
Data
Transmission
Format Data as is Data/Suffix Data/Suffix Data/
Suffix Prefix/
Data/
Suffix Data/
Suffix Data/
Suffix Data/
Suffix
Suffix CR/LF
(7013) CR (1013) CR (1013) CR
(1013) ETX
(1002) CR
(1013) CR
(1013) CR
(1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600 9600
Parity None Even Odd Odd Even None Odd None
Hardware
Handshaking None RTS/CTS
Option 3 RTS/CTS
Option 3 RTS/CTS
Option 3 None None RTS/CTS
Option 3 None
Software
Handshaking None None None None Ack/Nak None None None
Serial
Response
Time-out 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9
Sec. 9.9 Sec. 2 Sec.
Stop Bit
Select One One One One One One One One
ASCII
Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit 8-Bit 8-Bit
Beep On
Disable Disable Disable Disable Disable Disable Disable Disable
RTS Line
State Low High Low Low = No
data to
send Low High Low = No
data to
send Low
Prefix None None None None STX
(1003) None None None
*In the Nixdorf Mode B or OPOS/JPOS, if CTS is Low, scanning is disabled. When CTS is High, the
user can scan bar codes.
**If Nixdorf Mode B or OPOS/JPOS is scanned without the scanner connected to the proper host,
it may appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds of
cycling power to the scanner.