beautypg.com

Rts line state, Beep on -17 – Motorola LS3578 User Manual

Page 135

background image

RS-232 Interface 7 - 17

RTS Line State

This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High
RTS
line state.

*

Host: Low RTS

Host: High RTS

Beep on

Point-to-Point Mode Only

When this parameter is enabled, the scanner issues a beep when a character is detected on the RS-232
serial line. is issued to indicate an illegal entry or other important event.

Beep On Character

(Enable)

*

Do Not Beep On Character

(Disable)

NOTE

This parameter is not supported in Multipoint-to-Point Mode.