Motorola LS3578 - Manual (Page 22)

1 - 4 Symbol LS3578 Product Reference Guide
Figure 1-3 Cradle Back View
Connecting the Cradle
Important: Connect the interface cable and power supply (if necessary) in the following order to ensure proper operation of the
scanner and cradle.
Connecting STB3508/3578 Cradle
1. Insert the interface cable into the cradle's host port. See Figure 1-4 .
2. Connect the other end of the interface cable to the host.
3. If necessary, connect the power supply to the cradle's power port (if the interface requires, or to allow fast
charging of the scanner).
4. Connect the appropriate cable to the power supply and an AC power source, if necessary.
5. If applicable, thread the interface cable over the cable support hook and run the host and power cables into
their respective cable grooves.
6. Pair the scanner to the cradle by scanning the pairing bar code on the cradle.
7. If necessary, scan the appropriate host bar code (for non-autodetected interfaces). See the specific host
chapter.
Rubber Feet
(STB3508/3578 Only)
Mounting Screw Hole
Mounting Screw Hole
Power Cable Groove
Power Port Host Port
Host Cable Groove
Mounting Screw Hole
Converter Knob
Cable Hook