MITSUBISHI ELECTRIC MSZ-FD25VAS - Manual (Page 36)

36
11 DISASSEMBLY INSTRUCTIONS
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the
locking mechanism.
1 Slide the sleeve.
2 Pull the terminal while
pushing the locking
lever.
1 Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
MSZ-FD25VA MSZ-FD25VAS MSZ-FD35VA MSZ-FD35VAS
OPERATING PROCEDURE PHOTOS
Photo 1
1. Removing the panel
(1) Press and unlock the knobs on both sides of the front
panel and lift the front panel until it is level. Pull the hinges
forward to remove the front panel.
(2) Remove the horizontal vanes.
(3) Remove the screw caps of the panel. Remove the screws.
(See Photo 1)
(4) Hold the lower part of both ends of the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
NOTE :
Turn OFF power supply
before disassembling.
Screws of the panel
Front panel Horizontal vane
OBH488-2.qxp 07.8.9 11:49 AM Page 36