MITSUBISHI ELECTRIC MSZ-FD25VAS - Manual (Page 16)

16
● Indoor unit installation location and air-conditioning area
· Be sure to set the slide switch inside the remote controller to an appropriate position in accordance with the installed
position of the indoor unit. If the switch is not set correctly, the air conditioner may not function properly.
(Refer to "Remote controller in SERVICE FUNCTIONS".)
Installed at left Installed at center Installed at right
LEFT RIGHT LEFT RIGHT LEFT RIGHT
To air-condition mainly
the left area of the room To air-condition the entire room
The horizontal air flow direction and in-
door unit display are switched accord-
ing to the room temperature (floor/wall). To air-condition mainly
the right area of the room
Remote controller button
Press AREA button
to select LEFT.
Press AREA button to select AUTO.
Press AREA button
to select RIGHT.
i-see Sensor operation
Control range
of horizontal air
flow direction.
The vertical air
flow direction
conforms to the
setting on the
remote controller.
(The horizontal
air flow direction
is controlled in
this range.) Installed
at center
Installed
at left
Installed
at right
Indoor unit
display
AREA
Remote controller display
or or
Lighted
Not lighted
L R L R L R L R L R
Ex.) In COOL mode
Moving of horizontal air flow direction
Indoor unit
display
NOTE
·
·
Indication of AREA setting
Lighted
Not lighted
The horizontal air flow direction changes if i-see Sensor detects approx. 3 : temperature difference.
In AUTO of AREA setting, both right and left lamps are lighted when the room is evenly air-conditioned.
AREA R L AREA R L
AREA R L
The indoor unit delivers cold air detecting the warm area in the room.
Daytime Nighttime
Warm area Cold area
Approx. 150 degrees
● When AREA is set to AUTO
•The vertical vane is controlled to maintain uniform temperature in the whole room.
•The i-see Sensor moves in a range of 150 degrees detecting floor/wall temperature of 3 areas
(left, right, center). Therefore, the detected temperatures may be different from the temperatures
measured on commercial thermometers depending on the condition or temperature
distribution on the floor and/or wall.
OBH488-1.qxp 07.8.9 4:06 PM Page 16