Multi-Tech Systems ISI5634PCI/4/8 - Manual (Page 69)

69
Chapter 3—Software/Driver Installation
RPM, you will need to use the ‘--force’ option in the RPM command as
in step 5b below.
5a. For RPM version 6.2:
Copy the RPM to a temporary folder. In this example, we’ll use /isi.
Installation is in three parts, building the ‘isicom-smp.spec’ file from
the source file, then building the actual RPM from that “spec” file, and
finally, installing the RPM. Do not type the quotation marks shown in
the commands below.
- Run “
rpm -i /isi/isicom-1.1-3.src.rpm
”.
- Run “
rpm -ba /usr/src/redhat/SPECS/isicom-
smp.spec
”.
- Run “
rpm -ihv /usr/src/redhat/RPMS/i386/isicom-
1.1-3.i386.rpm
”
- Reboot the system, either using the command “
init 6
”
or your favorite method.
5b. For RPM version 7.0:
Copy the RPM to a temporary folder. In this example, we’ll use /isi.
Installation is in three parts, building the ‘isicom-smp.spec’ file from
the source file, then building the actual RPM from that “spec” file, and
finally, installing the RPM. Do not type the quotation marks shown in
the commands below. Replace the x below with the actual version
numbers being used.
- Run “
rpm -i /isi/isicom-1.2-3.src.rpm
”.
- Run “
rpm -ba /usr/src/redhat/SPECS/isicom-
rh7.spec
”.
- Run “
rpm -ihv --force /usr/src/redhat/RPMS/
i386/isicom-1.2-3.i386.rpm
”.
- Reboot the system, using either the command “
init 6
”
or your favorite method.